Command Line Instal­lation

Unat­tended Instal­lation via the Command Line

For automated rollouts or setups handled by IT partners, the installer can also be run without user interaction.

Example:

./setup.exe --output="C:\KlardatenDatevService" --install-datev-user --install-service --start-service

Basic instal­lation para­meters

• --output="C:\KlardatenDatevService": Required for command-line installations. Defines the target directory. Custom paths should be wrapped in quotes so backslashes are preserved.
• --install-service: Creates a Windows service named Klardaten DATEV Connector with automatic startup. If the service already exists, it is recreated.
• --start-service: Starts the Windows service automatically after installation.
• --install-userless: Suppresses the warning when the service is installed without a Windows user. This is useful if credentials will be set later, for example remotely.

Windows and DATEV users via the command line

Create a new user

• --install-datev-user: Creates the Windows user klardaten and the matching DATEV user.
• -s DATEVconnect.Domain="domain.ad.example.com": Overrides the automatically detected domain if necessary.

Use an existing user

If an existing Windows and DATEV user should be used, the values must be set explicitly:

• -s DATEVconnect.IsConfigured=true
• -s DATEVconnect.Username="windowsUsername"
• -s DATEVconnect.Domain="domain.ad.example.com"
• -se windows.user.password="windowsPassword"

Secret values should always be passed with -se instead of -s so they are stored encrypted on the system.

Config­uration values during instal­lation

Runtime parameters can be set directly during installation:

• -s <key>=<value>: Changes a configuration value in the current environment file, for example appsettings.Production.json. This flag can be used multiple times.
• -se <key>=<value>: Stores a secret value in encrypted form. Internally, Windows DPAPI is used, so the value can only be decrypted on the same system.

Example:

./setup.exe --output="C:\KlardatenDatevService" -s DATEVconnect.DatevGroup="My Datev Group" -se windows.user.password="Windows user password"

Debugging and devel­opment

The installer also supports a few parameters for operation, debugging, and development:

• --dev: Runs the application in PowerShell instead of starting it as a Windows service.
• --ui: Forces the UI installer instead of switching directly to the service path.
• --stop-watchdog: Stops all existing watchdog services until the main service starts again.
• --start-update: Performs update-related finalization tasks. This parameter is used internally during the update process.